Contex Roll Scanner Instructions

Before Scanning

1. Yellow power light on scanner should be ON, but all other lights OFF. Otherwise, Restart (See below).
2. No stickers, tape, dots or layers can go into scanner. Thin paper only.
3. If pastels or ANYTHING is on drawing that might rub off on scanner use clear acetate sheet from A&A supply to protect scanner from gunking up.
4. Insert graphic face down centered and straight until scanner 'grabs' the paper.

Scanning

1. Start Wide Image on Computer desktop
2. In Scan Setup set PRESET to None
3. MODE is graytone or 24 Bit Color
4. RESOLUTION is dots-per-inch
5. Set PAPER SIZE to AUTO PAPER SIZE (Click Arrow to RIGHT) so that AUTO IMAGE WIDTH shows.
6. Click GREEN CIRCLE to start scan.
7. CHANGE the location scan is to be saved to Temp drive: S: or T: and type in name. Note: Paper will roll down to check width, then pull back to top and then scan.
8. Push the BLUE down switch to push the paper out at the bottom of the scanner. Note: If streaks appear down the length of scan, scanner is dirty
9. Log out when done

To Restart Scanner

1. Power Off Computer
2. Power Off Scanner and count to 10 to allow motors to stop turning.
3. Power On Scanner
4. Power On Computer
5. Red lights will flash on scanner for 5 minutes - when only the yellow Power Light is on, Scanner is ready.